Home.

MineCraft.

Vans / Trucks.

Shop Fronts.

Road Cars.

Race Cars.

    Visor Stickers    .

Clothes.

Other.

Application.

Links.

Contact.

Redsigns,custom graphics , race car graphics , van signs , van graphics , medway , chatham , gillingham , rochester , kent , vinyl sign , stickers, van , designtech , designtechgraphics , designtech graphics , race car stickers , motaworld racing , motaworld , custom vinyl , car stickers , van stickers , minecraft , mine craft logo

 

Info@RedSigns.co.uk

0777 5584059

 

Installation of Graphics onto Glass

 

You need: spray type bottle filled with water, a credit card, and a friend.

 

First, you must clean the area you want to stick them on to, you need to remove any dirt / wax / polish that is on the glass, brake cleaner or a wetted page from a newspaper are fine, NOT GLASS CLEANER (Please refer to your owner’ s manual first, and use what they recommend !!)

 

Peel off the paper backing, so the graphics are attached to the application tape.

 

Get your friend to generously spray the back of the graphics with the water, YES the sticky bit!!! Then generously spray the area it is to be applied to, and stick it on. The water will allow you to slide the graphics into the correct position.

 

When it is in the right place, hold one end of the application tape against the car with your fingers and with your credit card slowly ‘stroke’ it along the length of the graphics away from your fingers, this should push most of the water mix out from under the graphics.

 

Wait about 20 minutes, and then gently remove the application tape.

 

If the weather is a bit cold, then you can use a hair dryer to slightly heat the application tape so they stick better.

 

The car should not be washed or waxed for a couple of days (the graphics take about 48 hours to fully cure)

 

Jet washes and carwashes should be avoided (as with all other type of graphics)

 

 

Installation of Graphics onto Paintwork

 

You need: spray type bottle filled with water and 2 drops of washing up liquid in it, a credit card, and a friend.

 

First, you must clean the area you want to stick them on to, you need to remove any wax or polish that is on the car, rubbing alcohol / t-cut / brake cleaner or something similar (Please refer to your owner’s manual first, and use what they recommend !!)

 

Use some masking tape to ‘line up’ the area you want to apply your graphics to. (Wonky graphics never look good, unless it is deliberate)

 

Peel off the paper backing, so the graphics are attached to the application tape.

 

Get your friend to generously spray the back of the graphics with the water / washing up liquid mix, YES the sticky bit!!! Then generously spray the area it is to be applied to, and stick it on. The water will allow you to slide the graphics into the correct position.

 

When it is in the right place, hold one end of the application tape against the car with your fingers and with your credit card slowly ‘stroke’ it along the length of the graphics away from your fingers, this should push most of the water mix out from under the graphics.

 

Wait about 20 minutes, and then gently remove the application tape.

 

If the weather is a bit cold, then you can use a hair dryer to slightly heat the application tape so they stick better.

 

The car should not be washed or waxed for a couple of days (the graphics take about 48 hours to fully cure)

 

Jet washes and carwashes should be avoided (as with all other type of graphics)